Brewer Element Treatment 2130/2140 Manuel d'utilisateur

Document 101292 RevAPrinted in USA © 20101Document 101292 RevAPrinted in USA © 2010Overview ...

Document 101292 RevAPrinted in USA © 201010MODELS 2130 and 2140 STEP 8STEP A: Insert the Shelf through either end of the Table. Positon the Shelf so t

Document 101292 RevAPrinted in USA © 201011Leveling the Table A Leveling Screw Pad is located at each corner under thetable’s base. Adjust the four Le

Document 101292 RevAPrinted in USA © 201012Preventative Maintenance• Inspect the mechanical functions to ensure satisfac-tory operation.• Check fasten

Document 101292 RevAPrinted in USA © 20102MODELS 2130 & 2140For the above models you will receive two separate cartons: a frame carton, and an uph

Document 101292 RevAPrinted in USA © 20103Screw CScrew CNotchSTEP A: Start with table frame inverted: note the position of the Notch in the drawing ab

Document 101292 RevAPrinted in USA © 20104Screw BScrew BScrew BScrew BMODEL 2130 and 2140 STEP 2STEP A : With table in the upright position install Sh

Document 101292 RevAPrinted in USA © 20105MODELS 2130 and 2140 STEP 3STEP A: Remove 2 Upper Leg Screws at Head End of the Table, one on each of the tw

Document 101292 RevAPrinted in USA © 20106MODELS 2130 and 2140 STEP 4Backrest CatchScrew GNut HScrew BSTEP A: Install Backrest Catch as shown in the d

Document 101292 RevAPrinted in USA © 20107MODELS 2130 and 2140 STEP 5STEP A: Align holes in Hinge with holes in frame. Hinge must be oriented as show

Document 101292 RevAPrinted in USA © 20108STEP A: Lay upholstered backrest on Foot End of frame as shown.STEP B: Slide backrest down until it bumps up

Document 101292 RevAPrinted in USA © 20109MODELS 2130 and 2140 STEP 7Screw AScrew BFoot EndRoundedCornerBack SectionBackrestBracketSTEP A: Rotate Back