Brewer Element Treatment 2130/2140 Manuel d'utilisateur télécharger pdf (Page 8)

Document 101292 RevA

STEP A: Lay upholstered backrest on Foot End of frame as shown.

STEP B: Slide backrest down until it bumps up against Hinge.

STEP C: Insert the four backrest-to-hinge Screws F (1/4”-20 x 1”) and tighten.

STEP D: Insert Screws F (1/4”-20 x 1”) through Clevises and tighten. Note Clevis Tab orientation.

STEP E: Install Backrest Support with Clevis Pins and Cotter Pins.

STEP F: Insert Screws D (10-24 x 1 1/4”) through Bumpers and tighten.

STEP G: Thread Nut L (3/8”) completely onto J-Bolt R. Place Washer M onto J-Bolt and thread into backrest as

shown. Position J-Bolt toward head end of table as shown and tighten nut against backrest.

Screw F

Nut L

Washer M

Foot End

Screw D

J-Bolt R

Clevis Pin

Clevis Tab

Clevis Pin

Cotter Pin

Screw F

Clevis

Hinge

Bumper

Backrest Support

MODELS 2130 and 2140 STEP 6

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Brewer Element Treatment 2130/2140 Manuel d'utilisateur Page 8